Contour BLOOD GLUCOSE MONITORING SYSTEM Uživatelská příručka stáhnout pdf (Strana 13)

TESTING

6. Lift the device straight

up and away from the

skin without smearing

the blood.

Apply More Blood

to continue testing.

(E01)

Too Little Blood

Remove used strip.

Repeat test with new

strip.

9. If you have the AutoLog feature turned on, the AutoLog

screen appears. Your test result will not display until you

make a selection. Select Fasting, Before Meal, After Meal,

or No Mark by pressing the OK button when the selection

is highlighted.

CAUTION: If your result is above or below your set

Target ranges, you will always see your result without

pushing a button.

7. Test immediately after

you have formed a

small, round blood drop.

Getting a Blood Drop for Alternative Site Testing

Immediately touch the tip of the test strip to the drop of

blood. The blood is pulled into the test strip through the tip.

Do not test the blood sample from palm if you get:

• Smeared blood

• Clotted blood

• Runny blood

• Clear fluid mixed with the blood

8. Hold the tip of the test strip in the blood drop until the

meter beeps. Do not press the tip against the skin or

place the blood on top of the test strip or you could get

inaccurate results or errors.

If the first blood drop is not enough,

the meter will beep twice and display

“Apply More Blood to continue testing.”

You have about 30 seconds to apply

more blood onto the same strip.

If you do not re-apply enough blood

within about 30 seconds, you will see

a screen telling you to remove the strip

and start with a new strip.

Please see Test Results with AutoLog On, page 13, or Test

Results with AutoLog Off, page 15.

84194034_CntrNEXT_UG_ENca_FpBp_v1.indd 18-1984194034_CntrNEXT_UG_ENca_FpBp_v1.indd 18-19 7/8/14 9:08 AM7/8/14 9:08 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Komentáře k této Příručce

Žádné komentáře

Contour BLOOD GLUCOSE MONITORING SYSTEM Uživatelská příručka Strana 13

Komentáře k této Příručce